FSTRIMSection: Maintenance Commands (8)
Updated: Nov 2010
Index Return to Main Contents
NAMEfstrim - discard unused blocks on a mounted filesystem
SYNOPSISfstrim [-o offset] [-l length] [-m minimum-free-extent] [-v] mountpoint
DESCRIPTIONfstrim is used on a mounted filesystem to discard (or "trim") blocks which are not in use by the filesystem. This is useful for solid-state drives (SSDs) and thinly-provisioned storage.
By default, fstrim will discard all unused blocks in the filesystem. Options may be used to modify this behavior based on range or size, as explained below.
The mountpoint argument is the pathname of the directory where the filesystem is mounted.
OPTIONSThe offset, length, and minimum-free-extent arguments may be followed by binary (2^N) suffixes KiB, MiB, GiB, TiB, PiB and EiB (the "iB" is optional, e.g. "K" has the same meaning as "KiB") or decimal (10^N) suffixes KB, MB, GB, PB and EB.
- -h, --help
- Print help and exit.
- -o, --offset offset
- Byte offset in filesystem from which to begin searching for free blocks to discard. Default value is zero, starting at the beginning of the filesystem.
- -l, --length length
- Number of bytes after starting point to search for free blocks to discard. If the specified value extends past the end of the filesystem, fstrim will stop at the filesystem size boundary. Default value extends to the end of the filesystem.
- -m, --minimum minimum-free-extent
- Minimum contiguous free range to discard, in bytes. (This value is internally rounded up to a multiple of the filesystem block size). Free ranges smaller than this will be ignored. By increasing this value, the fstrim operation will complete more quickly for filesystems with badly fragmented freespace, although not all blocks will be discarded. Default value is zero, discard every free block.
- -v, --verbose
Verbose execution. When specified
will output the number of bytes passed from the filesystem
down the block stack to the device for potential discard. This number is a
maximum discard amount from the storage device's perspective, because
ioctl called repeated will keep sending the same sectors for discard repeatedly.
fstrim will report the same potential discard bytes each time, but only sectors which had been written to between the discards would actually be discarded by the storage device. Further, the kernel block layer reserves the right to adjust the discard ranges to fit raid stripe geometry, non-trim capable devices in a LVM setup, etc. These reductions would not be reflected in fstrim_range.len (the --length option).
Lukas Czerner <email@example.com> Karel Zak <firstname.lastname@example.org>
AVAILABILITYThe fstrim command is part of the util-linux-ng package and is available from ftp://ftp.kernel.org/pub/linux/utils/util-linux-ng/.
This document was created by man2html, using the manual pages.
Time: 05:34:26 GMT, December 24, 2015