TRACE\-CMD\-SPLITSection: [FIXME: manual] (1)
Index Return to Main Contents
NAMEtrace-cmd-split - split a trace.dat file into smaller files
The trace-cmd(1) split is used to break up a trace.dat into small files. The start-time specifies where the new file will start at. Using trace-cmd-report(1) and copying the time stamp given at a particular event, can be used as input for either start-time or end-time. The split will stop creating files when it reaches an event after end-time. If only the end-time is needed, use 0.0 as the start-time.
If start-time is left out, then the split will start at the beginning of the file. If end-time is left out, then split will continue to the end unless it meets one of the requirements specified by the options.
- If this option is not specified, then the split command will look for the file named trace.dat. This options will allow the reading of another file other than trace.dat.
By default, the split command will use the input file name as a basis of where to write the split files. The output file will be the input file with an attached '.#\' to the end: trace.dat.1, trace.dat.2, etc.
This option will change the name of the base file used.
-o file will create file.1, file.2, etc.
- This specifies how many seconds should be recorded before the new file should stop.
- This specifies how many milliseconds should be recorded before the new file should stop.
- This specifies how many microseconds should be recorded before the new file should stop.
- This specifies how many events should be recorded before the new file should stop.
This specifies the number of pages that should be recorded before the new file should stop.
Note: only one of *-p*, *-e*, *-u*, *-m*, *-s* may be specified at a time.
This option causes the break up to repeat until end-time is reached (or end of the input if end-time is not specified).
trace-cmd split -r -e 10000
This will break up trace.dat into several smaller files, each with at most 10,000 events in it.
This option causes the above break up to be per CPU.
trace-cmd split -c -p 10
This will create a file that has 10 pages per each CPU from the input.
Written by Steven Rostedt, <m[blue]email@example.com>
This document was created by man2html, using the manual pages.
Time: 05:29:11 GMT, December 24, 2015