sgpioSection: USER COMMANDS (1)
Updated: December 2007
Index Return to Main Contents
NAMEsgpio - captive backplane LED control utility
SYNOPSISsgpio [-h] [-V] [[-d|--disk <device>[,<device>...]] | [-p|--port <port>[,<port>...]]] [-s|--status <status>] [-f|--freq <frequency>]
DESCRIPTIONSerial General Purpose Input Output (SGPIO) is a communication method used between a main board and a variety of internal and external hard disk drive bay enclosures. This utility can be used to control LEDs in an enclosure. For more information about SGPIO, please consult the SFF-8485 Specification.
- -h, --help
- displays a short help text
- -V, --version
- displays the utility and AHCI SGPIO specification
- -d, --disk
- disk name of LED location. Names are sda,sdb,sdc,... Multiple names can be provided in a comma-delimited list.
- -p, --port
- SATA port number of LED location, can be used if a disk name is no longer valid. 0,1,2,3,... Multiple ports can be provided in a comma-delimited list.
- -s, --status
- status of the LED to set. LED status is: locate, fault, rebuild, off
- -f, --freq
Set the frequency at which the LED should blink (in Hz). Frequency should be an integer between 1 and 10.
- Set the locate LED on SDA with an Intel Intelligent backplane:
- sgpio -d sda -s locate
- Set the locate LED on SDA to flash at 3 Hz for non-intelligent backplanes:
- sgpio -d sda -s locate -f 3
- Set SATA port 2 with fault at a 3 Hz flash rate:
- sgpio -p 2 -s fault -f 3
- Set disks sda through sdf to fault:
- sgpio -d sda,sdb,sdc,sdd,sde,sdf -s fault
EXIT STATUSsgpio should return zero when successful. It will return with a non-zero value if there was a failure.
AUTHOREric R. Hall <Eric.R.Hall@intel.com>
This document was created by man2html, using the manual pages.
Time: 05:29:10 GMT, December 24, 2015